Differential primary gearset AW TF-60SN 09G (gear ratio 61 (4 notches, on the gear) / 15 (without notches, on the gears), countershaft bearings 19/13 rollers, Driven Transfer Gear 53 teeth)

Differential primary gearset AW TF-60SN 09G (gear ratio 61 (4 notches, on the gear) / 15 (without notches, on the gears), countershaft bearings 19/13 rollers, Driven Transfer Gear 53 teeth)

Before buying a kit, pay special attention and compare the gears of your transmission with the gears presented on the site according to the following main parameters:

•     Number of gear teeth
•     Gear outer diameter
•     Gear notches
•     Number of rollers on taper radial bearings of the intermediate shaft

Drive Transfer Gear  Output Gear (complete with support):
 

•     The number of teeth is 53 pcs.
•     The number of notches is 5 pcs.
•     Outer diameter of the gear - 141.60 mm

Differential ring gear 61 teeth, 4 notches:
 

•     The number of teeth is 61 pcs.
•     The number of notches is 4 pcs.
•     Outside diameter - 196 mm.
•     Gear width - 42 mm.
•     Number of mounting holes - 12 pcs.
•     The differential seat depth is 20 mm.

Intermediate shaft:

•     The total shaft height is 155 mm.

Countershaft bearings:

•     Tapered radial bearing (large, front) - 19 rollers.
•     Tapered radial bearing (small, rear) - 13 rollers.

Driven Transfer Gear (48 gear teeth, 4 notches):
 

•     The number of notches on the gear is 4 pcs.
•     The outer diameter of the gear is 129.20 mm.
•     The width of the gear is 23.25 mm.

Gear 15 teeth (without notches):

•     Number of notches on the gear - without notches
•     The outer diameter of the gear is 54.95 mm.
•     Gear width - 46.90 mm.
• Parking gear:
•     The number of teeth is 13 pcs.