Input shaft with clutch drum E Clutch ZF 6HP26 ZF 6HP28 (total shaft height 304 mm, shaft diameter at the base of the drum 30 mm, 7 friction plates)

Input shaft with clutch drum E Clutch ZF 6HP26 ZF 6HP28 (total shaft height 304 mm, shaft diameter at the base of the drum 30 mm, 7 friction plates)

Before buying, carefully compare the shaft of your transmission with the shaft presented on the site. Particular attention should be paid to:

The total height of the shaft (should be measured taking into account the drum E Clutch)
The spline part can be of two types:
                                   1. with a flow separating splined part into two parts of equal length. The total height of this is 304 mm.
                                    2. without dividing groove, continuous splined part. The total height of such a shaft is 308 mm. If you are looking for such a shaft follow the link:  : Input shaft with E Clutch drum ZF 6HP26 ZF 6HP28 (total shaft height 308 mm, shaft diameter at the base 30 mm, 6 friction plates

1. The number of friction plates of the E Clutch pack. There are shafts with drum pack E Clutch for 5, 6, 7 friction plates.

​

• Overall height - 304 mm.
  The diameter of the working part of the shaft above the spline part is 18 mm.
  The height of the working part over the spline part is 18 mm.
  The diameter of the working part of the shaft at the base of the drum is 30 mm.
  The height of the shaft (from the base of the drum) is 244 mm.
  Drum height (taking into account ring gear) - 103 mm.
  The number of splines on the shaft is 27 pcs.
  The diameter of the splined part is 22 mm.
  Ring gear:

  The number of teeth is 71 pcs.
  The outer diameter of the ring gear is 136 mm.
  The inner diameter of the ring gear is 117 mm.
  The height of the ring gear (gear part) is 24 mm.
  E Clutch Steel & Friction plate kit:

  The total thickness of the pack (excluding the wave-shaped spring disk) is 31.05 mm.
  Thrust plate (clamping):

  Thickness - 2.95 mm.
  The inner diameter is 107 mm.
  The number of teeth is 24 pcs.
  The quantity of plates in a set is 1 pcs.
  Friction plate:

  Thickness - 1.60 mm.
  Outer diameter - 130.75 mm.
  The number of teeth is 30 pcs.
  The number of plates in the set is 7 pcs.
  Steel plate:

  Thickness - 2.35 mm.
  The inner diameter is 107 mm.
  The number of teeth is 24 pcs.
  The number of plates in the set is 7 pcs.